Главная
Авторизация
Фамилия
Пароль
 

Базы данных


Труды сотрудников ИБФ СО РАН - результаты поиска

Вид поиска

Область поиска
Формат представления найденных документов:
полныйинформационныйкраткий
Отсортировать найденные документы по:
авторузаглавиюгоду изданиятипу документа
Поисковый запрос: (<.>K=Quaterpolymers<.>)
Общее количество найденных документов : 3
Показаны документы с 1 по 3
1.


   
    Properties of a novel quaterpolymer P(3HB/4HB/3HV/3HHx) / T. G. Volova [et al.] // Polymer. - 2016. - Vol. 101. - P67-74, DOI 10.1016/j.polymer.2016.08.048 . - ISSN 0032-3861
Кл.слова (ненормированные):
Physicochemical and mechanical properties -- Polyhydroxyalkanoates -- Quaterpolymers -- Biocompatibility -- Cell culture -- Chain length -- Chains -- Decomposition -- 3-Hydroxyhexanoate -- Degrees of crystallinity -- Elongation at break -- Physico-chemical and mechanical properties -- Polyhydroxyalkanoates -- Quaterpolymers -- Short chain lengths -- Thermal decomposition temperature -- Film preparation
Аннотация: Cupriavidus eutrophus В10646 was used to synthesize a series of polyhydroxyalkanoate (PHA) quaterpolymers composed of the short-chain-length 3-hydroxybutyrate (3HB), 4-hydroxybutyrate (4HB), and 3-hydroxyvalerate (3HV) and the medium-chain-length 3-hydroxyhexanoate (3HHx). The molar fraction of 3HB in the quaterpolymers varied between 63.5 and 93.1 mol.%, 3HV – between 1.1 and 24.6 mol.%, 4HB – between 2.4 and 15.6 mol.%, and 3HHx – between 0.4 and 4.8 mol.%. The properties of PHA quaterpolymers were significantly different from those of the P(3HB) homopolymer: they had much lower degrees of crystallinity (up to 30–45%), and lower melting points and thermal decomposition temperatures, with the interval between these temperatures remaining practically unchanged. Films prepared from PHA quaterpolymers were rougher and more porous than P(3HB) films; they showed higher values of elongation at break (up to 6–113%), i.e. were more elastic. Films prepared from PHA quaterpolymers were biocompatible and had no toxic effect on mouse fibroblast NIH 3T3 cells. © 2016 Elsevier Ltd

Scopus,
Смотреть статью,
WOS
Держатели документа:
Siberian Federal University, 79 Svobodnyi Avenue, Krasnoyarsk, Russian Federation
Institute of Biophysics of Siberian Branch of Russian Academy of Sciences, Akademgorodok, Krasnoyarsk, Russian Federation
Institute of Chemistry and Chemical Technology of Siberian Branch of Russian Academy of Sciences, Akademgorodok, Krasnoyarsk, Russian Federation
L.V. Kirensky Institute of Physics of Siberian Branch of Russian Academy of Sciences, Akademgorodok, Krasnoyarsk, Russian Federation

Доп.точки доступа:
Volova, T. G.; Vinogradova, O. N.; Zhila, N. O.; Peterson, I. V.; Kiselev, E. G.; Vasiliev, A. D.; Sukovatiy, A. G.; Shishatskaya, E. I.

Найти похожие
2.


   
    Properties of PHA bi-, ter-, and quarter-polymers containing 4-hydroxybutyrate monomer units / N. Zhila, E. Shishatskaya // Int. J. Biol. Macromol. - 2018. - Vol. 111. - P1019-1026, DOI 10.1016/j.ijbiomac.2018.01.130. - Cited References:39. - The research was supported by the Russian Science Foundation (grant No. 17-15-01352). . - ISSN 0141-8130. - ISSN 1879-0003
РУБ Biochemistry & Molecular Biology + Chemistry, Applied + Polymer Science
Рубрики:
ALCALIGENES-FAECALIS T1
   COMAMONAS-ACIDOVORANS

   ENZYMATIC DEGRADATION

Кл.слова (ненормированные):
Polyhydroxyalkanoates -- 4-Hydroxybutyrate monomer units -- Physicochemical -- and mechanical properties
Аннотация: The present study investigates physicochemical, mechanical, and biological properties of polyhydroxyalkanoate (PHA) copolymers containing 4-hydroxybutyrate (4HB) synthesized in Cupriavidus eutrophus B10646 culture. In poly(3-hydroxybutyrate/4-hydroxybutyrate) [P(3HB/4HB)]bipolymers, 4HB varied between 10.4 and 75.0 mol%; in poly(3-hydroxybutyrate/3-hydroxyvalerate/4-hydroxybutyrate) terpolymers, 4HB constituted 28.7-55.6 mol%; and in poly(3-hydroxybutyrate/3-hydroxyvalerate/4-hydroxybutyrate/3-hydroxyhexanoate) quaterpolymers, 4HB varied between 9.3 and 13.3 mol%. The degree of crystallinity of P(3HB/4HB) copolymers decreased consistently with an increase in 4HB content, reaching 38%. The incorporation of 3-hydroxyvalerate and 3-hydroxyhexanoate into copolymers enhanced that effect. The effect of 4HB monomer units on temperature properties of copolymers was exhibited as lowering of the melting temperature and crystallization temperature, which improved the processing-related properties of the copolymers. All copolymers containing 4HB showed enhanced elongation at break compared to poly(3-hydroxybutyrate). Polymer films prepared from PHA5 with different chemical composition had similar microstructure and porosity and had no toxic effect on mouse fibroblast NIH 3 T3 cells, proving their high biocompatibility. (C) 2018 Elsevier B.V. All rights reserved.

WOS,
Смотреть статью
Держатели документа:
Siberian Fed Univ, 79 Svobodnyi Ave, Krasnoyarsk 660041, Russia.
RAS, Krasnoyarsk Sci Ctr, Fed Res Ctr, Inst Biophys,SB, Krasnoyarsk 660036, Russia.

Доп.точки доступа:
Zhila, Natalia; Shishatskaya, Ekaterina; Russian Science Foundation [17-15-01352]

Найти похожие
3.


   
    Synthesis and characterization of multicomponent PHAs / E. G. Kiselev, A. D. Vasiliev, T. G. Volova // J. Sib. Fed. Univ. - Biol. - 2021. - Vol. 14, Is. 1. - С. 97-113, DOI 10.17516/1997-1389-0325. - Cited By :1 . - ISSN 1997-1389
Кл.слова (ненормированные):
Biosynthesis -- Copolymers -- Physicochemical properties -- Polyhydroxyalkanoates (PHAs) -- Precursor substrates
Аннотация: Cupriavidus necator B10646 bacterial cells were cultivated in the mode of synthesis of the reserve polyhydroxyalkanoates (PHAs) in the growth medium that contained, in addition to glucose as the main substrate, precursor substrates of the monomers of various monocarboxylic acids - salts of valeric and hexanoic acids, propionate, and ?-butyrolactone. PHA terpolymers and quaterpolymers with different compositions and proportions of monomers were synthesized, and their physicochemical properties were studied. The terpolymers were composed of monomers of 3-hydroxybutyrate (3HB), 3-hydroxyvalerate (3HV), 4-hydroxybutyrate (4HB), or 3-hydroxyhexanoate (3HHx) and had the following compositions: P(3HB/3HB/4HHx) and P(3HB/3HV/4HHx). The quaterpolymers had the following composition: P(3HB/3HV/4HB/3HHx). All copolymer samples, regardless of the composition and proportions of monomers, had lower molecular weights and higher polydispersity values compared to the highly crystalline 3-hydroxybutyrate homopolymer, but retained thermal stability properties, with a difference between the melting point and thermal degradation of at least 100-110 °C. The inclusion of 3HV, 4HB, and 3HHx monomers in the C-chain of 3HB caused changes in the crystalline to amorphous phase ratio and a significant decrease in the degree of crystallinity (Cx), which depended on the type of monomers and their contents in the copolymer. The maximum decrease in Cx (9-17 %) was detected in the P(3HB/3HV/4HB) terpolymer and the P(3HB/3HV/4HB/3HHx) quaterpolymer (30-36 %). The study confirms that there is the possibility of synthesizing polymers with various compositions, including new ones, which differ significantly in their basic properties. © Siberian Federal University. All rights reserved.

Scopus
Держатели документа:
Institute of Biophysics SB RAS, FRC Krasnoyarsk Science Center SB RAS, Krasnoyarsk, Russian Federation
Siberian Federal University, Krasnoyarsk, Russian Federation
L.V. Kirenskii Institute of Physics SB RAS, FRC Krasnoyarsk Science Center SB RAS, Krasnoyarsk, Russian Federation

Доп.точки доступа:
Kiselev, E. G.; Vasiliev, A. D.; Volova, T. G.

Найти похожие
 

Другие библиотеки

© Международная Ассоциация пользователей и разработчиков электронных библиотек и новых информационных технологий
(Ассоциация ЭБНИТ)