Библиотека института физики им. Л.В. Киренского СО РАН

Главная

Базы данных

Труды сотрудников ИФ СО РАН - результаты поиска

Вид поиска

Каталог книг и брошюр библиотеки ИФ СО РАН

Каталог журналов библиотеки ИФ СО РАН

Труды сотрудников ИФ СО РАН

Область поиска

Найдено в других БД:

Каталог книг и брошюр библиотеки ИФ СО РАН (1)

Формат представления найденных документов:
полный	информационный	краткий

Поисковый запрос: (<.>K=fracture<.>)

Общее количество найденных документов : 1

Вид документа : Статья из журнала
Шифр издания :
Автор(ы) : Narkevich N., Vlasov I., Volochaev M. N., Gomorova Y., Mironov Y., Panin S., Berto F., Maksimov P., Deryugin E.
Заглавие : Low-temperature deformation and fracture of Cr-Mn-N stainless steel: Tensile and impact bending tests
Место публикации : Metals. - 2023. - Vol. 13, Is. 1. - Ст.95. - ISSN 20754701 (eISSN), DOI 10.3390/met13010095
Примечания : Cited References: 41. - The research was funded by RSF, project No. 22-29-00438. The low-temperature tensile tests were carried out in accordance with the state assignment for the ISPMS SB RAS, project No. FWRW-2021-0009
Аннотация: The paper presents the results of tensile and impact bending tests of 17%Cr-19%Mn-0.53%N high-nitrogen austenitic stainless steel in temperatures ranging from −196 to 20 °C. The steel microstructure and fracture surfaces were investigated using transmission and scanning electron microscopes, as well as X-ray diffraction analysis. The steel experiences a ductile-to-brittle transition (DBT); however, it possessed high tensile and impact strength characteristics, as well as the ductile fracture behavior at temperatures down to −114 °C. The correspondence between γ–ε microstructure and fracture surface morphologies was revealed after the tensile test at the temperature of −196 °C. In this case, the transgranular brittle and layered fracture surface was induced by ε-martensite formation. Under the impact bending test at −196 °C, the brittle intergranular fracture occurred at the elastic deflection stage without significant plastic strains, which preceded a failure due to the high internal stresses localized at the boundaries of the austenite grains. The stresses were induced by: (i) segregation of nitrogen atoms at the grain boundaries and in the near-boundary regions, (ii) quenching stresses, and (iii) reducing fcc lattice volume with the test temperature decrease and incorporation of nitrogen atoms into fcc austenite lattice. Anisotropy of residual stresses was revealed. This was manifested in the localization of elastic deformations of the fcc lattice and, consequently, the stress localization in 100-oriented grains; this is suggested to be the reason of brittle cleavage fracture.
Смотреть статью,
Scopus,
Читать в сети ИФ
Найти похожие